![]() ![]() I have 16 sensors connected to the 16 analog pins on an Arduino mega Board. I'm having some trouble with the next project, I hope that you guys can give me some advice! ![]() I am quite new to Labview and Arduino, so I apologize if I use the incorrect terms. VISA reading significantly slows down to 20 Hz (Labview, Arduino Xbee project) You just need to change the code so default baud rate set to 9600 In the code it said essentially that default baud rate is 115200, if you are not using the Arduino Mega. #define DEFAULTBAUDRATE 9600 / / sets the default series transmission speed (it should match to the specified baud rate in LabVIEW) On this folder, open LabVIEWInterface.h with Arduino IDE If you installed labview for arduino interface you should find it under C:\Program NIUninstaller Instruments\LabVIEW (your version number)\vi.lib\LabVIEW Interface for Arduino\Firmware\LIFA_Base\LabVIEWInterface I did a little research on the LIFA firmware and: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |